HRIBF RIB Intensities (2007)  

In order to use the
RIB yields 2007 table
you may also need to use the
Tandem voltage & charge state fraction estimation calculator.
The yields given are for the
maximum charge state fraction possible using either single stripping
(typically 20%) or double stripping (typically 4%). If you need to
estimate a yield off the maximum, then run the voltage/charge state
fraction calculator for energies which give the maximum fraction
(single or double stripped) and again for your desired energy. The ratio
of charge state fractions multiplied by the reported intensity is
your estimated beam on target.
An illustrative example for
^{132}Sn is available.
Yields for a given isotope that have been accelerated through the tandem are given in red. To better estimate yields of a specific isotope of a given mass, its low intensity yield (black) is scaled by the low intensity yield of a different mass of the same isotopes times its yield accelerated by the tandem. For example, although we have not yet accelerated doublestripped ^{134}Sb we can compare the low intensity results for ^{129}Sb and the actual accelerated yield and devise appropriate scaling for the ^{134}Sb yield on target. The values given reflect the maximum ORIC beam possible for the appropriate ISOL target or regulatory limitation. 
For questions about this page please contact the HRIBF User Liaison. This file last modified Thursday March 01, 2007 